Your local Knoxville plumbing technicians are experts in their field and they’re here to help YOU with all of your plumbing needs. Flush the toilet to bail as much water as. If you run into any problems with your home plumbing, or you have any questions about your plumbing, do not hesitate to reach out to our professionals here at Pipe Wrench Plumbing, Heating & Cooling. You should be able to turn the valve by hand, but if it hasnt moved in several years, it might be sticky. Might be more than a diy job depending on your skills and how keen you are. Might have to alter pipe to fit the new inlet as different lengths. FLUIDMASTER are a good brand with the brass thread inlet. Is it cracked? There may be something wrong with the handle - check the nuts inside of the tank that hold the handle in place. Replace parts and fill with water to check for leaks. If everything in the tank seems to be working properly, check the handle itself. When flappers are old, they can get stuck. Make sure that the flapper inside of your tank isn’t worn out. Then, spray down the stuck valve with penetrating oil. If the chain is too long, the flapper will only lift a tiny bit or not at all. Start by turning off the main water shut off valve to the house. If you happen to find that the flush valve is an uncommon size, such as 3.5 inches, try. When you flush your toilet, the flapper or seal should rise (about 90 degrees). Typically, you have to stick to the size that is in there already.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |